BevRC
HL 4225 610KV HIGH EFFICIENCY HEAVY DUTY DISC MOTOR
| Model | W42-25 610KV |
| Idel current | 0.3A at 7.4V |
| Net weight | 87g |
| Max cell number supported | 4S Lipo |
| Max current | 22A |
| Recommended ESC | 30A |
| Working current | <16A |
| Max power | 330W |
| Internal resistance | 0.091Ω |
| Application | specially designed for quadcopter and multi-rotor aircrafts. |
BevRC
AV OUT CABLE FOR HERO3
| black | GND |
| red | audio out |
| white | video out |
| black | GND |
| red | DC5V power in with enough driving ability power source, 5V UBEC is recommended. |
Note: Power the Hero3 with a 5V UBEC, don't power it with your radio receiver which can't offer enough currrent., The pins' definition is:, Female connector cable:, male connector cable:,
BevRC
CYCLOPS STORM OSD 2013 VERSION V1.03 FIRMWARE MAINBOARD
2: Re-design of power system, you won't burn the OSD even you use high power video Tx and camera., 3: Stronger filter for the video Tx and camera, better video quality offered, 4: Fully tested with various wrongly connection issues, no hard to OSD., 5: The botton of the mainborad is more flat, which is easier to put horizontly, also a new platic box for the mainboard is under production also, everyone will get a box later for free.,
New design of PCB board for the mainboard 1：Longer distance ...BevRC
RC701 5.8GHZ DIVERSITY HIGH LIGHT HD 7-INCH MONITOR
| Screen size | 7 inch |
| screen type | TFT LCD screen/long life, LED backlight |
| Resolution | 800*480 |
| Brightness | 450cd/m2 |
| contrast | 500 |
| Working Voltage | DV 7-12V(center positive) or 11.1v 3s lipo battery |
| Power consumption | < 8w |
| size | 180*120*23mm |
| Working Temp | -10--+65 degrees |
| CH1 | 5705Mhz |
| CH2 | 5685Mhz |
| CH3 | 5665Mhz |
| CH4 | 5645Mhz |
| CH5 | 5885Mhz |
| CH6 | 5905Mhz |
| CH7 | 5925Mhz |
| CH8 | 5945Mhz |
Specification:, View angle:, 140/120degree(Horizontal/Vertical), Features:, 1: Built-in Dual Receiver Automatically for best reception Automatic Antenna Swithcing, 2: Dual buffered AV output, 3: Can receive 2 different channels at the same time, 4: Not affect by 2.4Ghz R/C radios, 5: AV receiver with Diversity inputs, 6: Small, light weight, durable., Working frequencies:,
Built-in 5.8G Dual diversity receiver automatically for best reception Built-in ...BevRC
FRSKY TFR8SB- COMPATIBLE WITH FUTABA FAAST RADIO WITH SBUS AND RSSI PORT
| FASST 2.4GHz Air Systems (7CH Mode/Multi Mode) | 6EX, 7C, TM-7, TM-8, T8FG, T10C, TM-10, T10CG, T12Z, T12FG, TM-14, T14MZ, etc |
| Model | TFR8SB (8CH FASST compatible receiver with RSSI & SB ports) |
| Dimension | 44.5*27.5*17mm |
| Operating Voltage Range | 3.5~10V |
| Operating Temperature Range | -10℃~80℃ |
| Mode A | RED LED blinks |
| Mode B | GREEN LED blinks |
:11.5g, :, 14ms (FS – Normal Speed Mode), Note: Be sure that when using battery or regulated output from ESC, the capacity must meet the usage conditions of servos., Use native failsafe position preset on the transmitter side:, If not disabling failsafe on the transmitter side, TFR8SB will use native failsafe position preset on the transmitter side., Set failsafe on TFR8SB side:, TFR8SB supports failsafe function for all channels. Follow the steps below to set failsafe on TFR8SB:, 1) Bind the receiver first, and disable failsafe on the transmitter side;, Note: HS mode is only applied for high-speed digital servos. Other servos should select FS mode, otherwise servos will get hot or even burn out., Note: Do not perform linking procedure while motor’s main wire is connected or engine is operating, otherwise damage may occur. After linking is completed, recycle the receiver power and check if the receiver is really under control by linked transmitter.,
It's a good choice for your multi-rotor with Naza or ...BevRC
FRSKY LCD DISPLAY
| Model | FLD-02 |
| Compatibility | FrSky DFT, DJT and DHT |
| Dimension | 55*40*12mm |
| Pixel | 128*64 |
| Model | FLD-02 |
| Compatibility | FrSky DFT, DJT and DHT |
| Dimension | 55*40*12mm |
| Pixel | 128*64 |
| Blade | Blade Number |
| Volt ratio | A1 & A2 Voltage Division Ratio |
| Unit Set | Speed (m/s or MPH) |
| Alarm Set | A1_1/2, A2_1/2, RSSI_1/2 |
1.1 Specifications:, 1.2 Features:, 1) Show all connected sensors data;, 2. Installation:, Connect FrSky FLD-02 to the UART and power connection on FrSky telemetry module (Rxd, Txd, +5V, GND) by the provided cable. Confirm the orientation is correct and make sure both switches on the telemetry module are OFF, 3 Screen structures:, 3.1 Main Screen, Note: Make sure the battery voltage division ratios are programmed in accordance with those of connected battery voltage sensors., :, , Note: Screen-3 shows up only when FrSky Lipo Voltage Sensor (FLVS-01) is connected, otherwise Screen-4 will show up after Screen-2.,
Product Show FLD-02 Category：Accessories 1.Introduction 2) Capable of programming alarm ...BevRC
FRSKY SENSOR HUB
| Dimension | 37*30*8mm |
| Operating Voltage Range | 4~10V |
| Operating Temperature Range | -20~80℃ |
| Feature | Firmware upgradable |
| Fuel | Fuel Gauge Sensor |
| GPS | GPS |
| Vario | Variometer Sensor |
| Volt | Lipo Voltage Sensor |
| Temp1/2 | Temperature Sensor |
| Power | Power Supply |
| RPM | RPM Sensor |
| Acc | Triaxial Acceleration Sensor |
| Data | use provided cable to connect to digital side port (G, TX, RX) of FrSky telemetry receiver |
: 37*30*8mm, :, Operating Voltage Range, : 4~10V, : -20~80℃, : Firmware upgradable, :, , Installation:, It is recommended to take the length of all sensors’ wires into consideration before mounting, and use double-sided tape to install FrSky sensor hub at an appropriate place in the model.,
Product Show Sensor Hub and Sensors Category：Accessories FrSky Sensor Hub ...BevRC
OMWAY 5.8G 400MW TX(COMPATIBLE WITH ALL 5.8G RXS WE SELL)
| Frequency | 5.8G wide-band FM video/audio tx |
| Power | 400mw |
| Channels | 2 modes |
| Weight | 14g only |
| Sterieo audio | L/R audio channe; |
| Input Voltage | 7-16v |
Specatations:, 5740-5860MHz(7-channel),
This is the first 5.8G solution support both the Fatshark/ImmersionRC(airwave/NexwaveRF) ...BevRC
BEV BLUE 5.8G CLOVERLEAF ANTENNA SET(2 ANTENNAS,SMA,FOLDABLE)
| Frequency Range | 5725-5875Mhz |
| Impedance | 50ohm |
| VSWR | <1.3 |
| Gain | 2dBi |
| Polarization | Right hand circularly polarized |
| Max power input | 20W |
Spec:,
The new batch of CL antennas with foldable cable,easier to ...BevRC
BEV BLUE 5.8G CLOVERLEAF ANTENNA 4 LOBES FOR RX(SMA,FOLDABLE)
| Frequency Range | 5725-5875Mhz |
| Impedance | 50ohm |
| VSWR | <1.3 |
| Gain | 2dBi |
| Polarization | Right hand circularly polarized |
| Max power input | 20W |
Spec:,
The new batch of cloverleaf antenna with foldable cable, the ...BevRC
BEV RED 5.8G CLOVERLEAF ANTENNA 3 LOBES FOR TX(RP-SMA,FOLDABLE)
| Frequency Range | 5725-5875Mhz |
| Impedance | 50ohm |
| VSWR | <1.3 |
| Gain | 2dBi |
| Polarization | Right hand circularly polarized |
| Max power input | 20W |
Spec:,
The new batch of cloverleaf antenna with foldable cable, the ...BevRC
BEV RED 5.8G CLOVERLEAF ANTENNA 4 LOBES FOR RX(RPSMA,FOLDABLE)
| Frequency Range | 5725-5875Mhz |
| Impedance | 50ohm |
| VSWR | <1.3 |
| Gain | 2dBi |
| Polarization | Right hand circularly polarized |
| Max power input | 20W |
Spec:,
The new batch of cloverleaf antenna with foldable cable, the ...BevRC
BEV RED 5.8G CLOVERLEAF ANTENNA SET(2 ANTENNAS,RP-SMA,FOLDABLE)
| Frequency Range | 5725-5875Mhz |
| Impedance | 50ohm |
| VSWR | <1.3 |
| Gain | 2dBi |
| Polarization | Right hand circularly polarized |
| Max power input | 20W |
Spec:,
The new batch of CL antennas with foldable cable,easier to ...BevRC
BEV BLUE 5.8G CLOVERLEAF ANTENNA 3 LOBES FOR TX(SMA,FOLDABLE)
| Frequency Range | 5725-5875Mhz |
| Impedance | 50ohm |
| VSWR | <1.3 |
| Gain | 2dBi |
| Polarization | Right hand circularly polarized |
| Max power input | 20W |
Spec:,
The new batch of cloverleaf antenna with foldable cable, the ...BevRC
TAROT T2D GOPRO HERO3 TWO-AXIS BRUSHLESS GIMBAL/WITH GYRO
| 7, support Receiver | conventional receiver, S-BUS receiver, DSM2/DSMJ/DSMX receiver |
| 8, support for remote devices | PPM/PCM/2.4G |
| 9, the working voltage | DC 7.4V ~ 14.8V (Recommended 12V, three lithium battery) |
| 10, working current | 200mA-500mA (power supply voltage and the motor related) |
| 11, the working environment temperature | -15 ℃ ~ 65 ℃ |
| 12, the processor | Dual 32-bit high-speed ARM core processor |
| 13, the sensor | Three rotor MEMS gyroscope rotor MEMS accelerometers and the three |
| 14, the maximum angular rate | 2000°/ sec |
| 15, the maximum acceleration | 16g |
| 16, the control frequency | 2000Hz |
| 17, the motor drive frequency | 20KHz (no noise smoothing driven) |
| 18, the control accuracy | 0.1° |
| 19, the control angle range | -45 °~ 45 °(roll), -135°~ 90°(tilt) |
| 20, pose solver algorithms | PTZ dedicated brushless motor decoupled EKF algorithm |
| 21, for shooting equipment | GOPRO Hero3 |
| Weight | 195g |
Gopro two-axis brushless PTZ English software description and download link:, , Product Features:, 1, support GOPRO Hero3 video auxiliary output, Related Part Number:, Head hanging hook TL68A01, Specifications:, GOPRO brushless pan rack assembly TL68A08 x1,
Download the manual here. T-2D PTZ is TAROT company for ...